Buhler Farm King Grain Vac Conveyair 6640, Руководство оператора и каталог запасных частей

Страница: 37 / 62

37
Storage - Grain Vac
Storage
Prior to storage we recommend that you
thoroughly inspect your Grain Vac.
1. Replace any worn or damaged
components.
2. Wash and clean the machine. After
cleaning, run machine at low idle for 2-3
minutes to dry the internal components.
3. a - While machine is running at an idle,
open the cleaning port and inject a clean -
ing agent such as WD40 for 45 - 60 sec -
onds. This will coat the inside of the air
pump to help prevent rusting.
b - During storage or not in use for longer
periods of time, perform the following
procedure. Monthly, rotate air pump by
hand to ensure turning free. (Close belt
cover and fasten hood fastener latch.)
Now rotate air pump at an idle, open
airslide above air pump and inject a
cleaning agent such as WD40 for 45-60
seconds. This coats the inside of the air
pump to help prevent rust.
4. Lubricate all grease points. Make sure
all grease cavities have been filled with
grease to remove any water residue.
5. Retract and stow all components and
accessories and install cover over the
boom pivot. (Keeps out dirt and small
animals).
6. Inspect all hydraulic hoses, couplers,
fittings and lines. Tighten any loose fittings. Replace any hose that is badly cut, nicked,
abraded or is separating from the fitting.
7. Inspect, clean or empty the BPS.
8. Check the fluid level in the air pump oil
reservoirs. Add oil as required.
9. Touch up all paint nicks and scratches to help prevent rusting.
10. For storage, select an area which is dry and level. Make sure unit is firmly blocked and will not
tip or sink into a soft area. Place a plank under jack for added support.
11. Do not store polyhoses, steel flexes, aluminum tube wands or nozzles outside in the
elements. Always store them inside a dry atmosphere and lay them straight and flat. Do not
store them outdoors at anytime.
12. When machine is not in use, plug all inlets. Ensure lids and covers are installed and sealed
properly .
Inject
Cleaning
Agent
Here