8
1.
Set up the main track that the machine is to run on, parallel to the work-piece. Slide the
machine onto the track, front end first.
2.
Plug the machine into the power line of correct voltage, and push the RESET button.
3.
Push the red STOP button and use the toggle switches to move the machine and cross
rail to the starting position. Press the Reset button to make this the starting point.
4.
Set the speed knob for correct speed. Speed can be checked by moving the machine
manually using the toggle switches.
5.
If the required shape has not been programmed, refer to Shape Programming, and enter
the program. If the shape has been programmed, turn on the preheat gases, set the torch
height and ignite the torch.
6.
When the work piece is heated enough, press the black RUN button. The solenoid will
turn on the cutting oxygen, the machine will start moving along the programmed shape,
and at the end of the shape it will stop and turn off the solenoid. Manually turn of the
preheat gases. The machine is now ready for the next cut.
STEP BY STEP INSTRUCTIONS FOR OPERATION
