Buffalo TeraStation WSH5610, Руководство пользователя

Страница: 33 / 111

6
Select the recovery targets and click Next .
7
Step through the wizard to finish.
Replication
Replication copies all data from a share to a share on a different TeraStation. This is an easy way to configure a
reliable system to provide data protection in the event your main TeraStation fails. To configure replication, connect
an Ethernet cable to the LAN port of each TeraStation and follow the steps below.
Note:
Replication operation may not proceed properly if a large number of files or a large capacity file have been
replicated continually for a long time, causing too of a data load. Before starting replication, check if there is any
cause for operational issues.
Differences Between Buffalo Replication and DFS Replication
To use DFS Replication, your TeraStation needs to be joined to an Active Directory, while Buffalo Replication does
not require joining an AD domain. Buffalo Replication can also specify another TeraStation or LinkStation as a
replication destination.
If your environment must join the Active Directory domain, use DFS Replication. If joining the Active Directory is
not required, or if a TeraStation or LinkStation has been configured as the replication destination, using Buffalo
Replication is recommended.
Before Using Replication
• For best results, use static IP addresses with the same subnet masks for both replication TeraStations (source and
destination). If on a VPN network, configure the network settings so that broadcast packets are not dropped.
• Setting the TeraStation on a 1000 Mbps network is recommended.
32