Buell XB 2010, Руководство по обслуживанию

Страница: 538 / 714

6.22 SIDESTAND SWITCH (HDI)
SIDESTAND SWITCH (HDI)
Removal
1. Disconnect the sidestand switch from the harness between
the left ram air scoop and cylinder head next to the front
V-bracket to frame bolt.
2. Remove the two cable straps securing the sidestand har-
ness to the vertical leg of the V-bracket.
3. Remove the cable strap securing the sidestand switch
lead to the crank position sensor next to its own re-
closeable tree fastener clip.
4. Remove the sidestand switch harness from along the
inside of the vertical leg of the V-bracket from behind the
rear oil cooler bracket.
5. Pull the switch wire harness through the re-closeable tree
fastener clip on the muffler and route harness out the left
side of the vehicle.
6. Remove fastener securing the sidestand switch to the
sidestand bracket and remove sidestand switch and har-
ness.
Installation
1. Install fastener through the sidestand switch into the
sidestand bracket and tighten to 96-120 in-lbs (10.8-13.6
Nm).
2. Route the switch wire harness through the re-closeable
tree fastener clip on the muffler in order to secure the
switch harness from damage.
3. Continue routing the sidestand switch harness along the
front contour of the primary cover to the crank position
sensor wire.
4. Install a cable strap around the sidestand switch lead to
the crank position sensor next to its own re-closeable tree
fastener clip, which holds the crank sensor lead in place,
and then route the sidestand switch wire behind the rear
oil cooler bracket and up along the inside of the vertical
leg of the V-bracket and secure it with two more cable
straps.
5. The sidestand switch connection is on the harness
between the left ram air scoop and cylinder head next to
the front V-bracket to frame bolt.
HOME
6-64 2010 XB Service: Electrical