6
MA391572_13.5
[Original Instructions]
7/01/2013
Operation
The HandiMet 2 grinder is designed to perform manual grinding in a series of abrasive papers, 240, 320,
400, and 600 grit.
For best results, do not use heavily worn papers. Worn papers do not grind effectively and their use can
result in poorly prepared surfaces.
Water Control
The water flow is controlled by the Water Control Knob located on the HandiMet 2 top panel.
Adjust the Water Control Knob to provide a steady but gentle stream of water.
The proper water flow allows the abrasive paper to grind freely and effectively while flushing the
waste products away.
Too little water flow will produce an excess of build-up of sample debris on the abrasive paper
and reduce the paper’s grinding abilities.
Too much or excessive water flow will cause the sample to hydroplane on the abrasive surface
and will result in poor and ineffective grinding.
Figure 4 HandiMet 2 Operation Diagram