26
MA112680_39.3
[Original Instructions]
4/2014
Cleaning the Unit
The IsoMet 4000 Linear Precision Saw should be cleaned periodically to prevent build-up of
cutting residue and cutting fluids and the coolant line can be used to rinse the saw.
The linear rails should be cleaned daily and with heavy use should be lubricated with light oil.
Do not use WD40™ on the linear rail bearings, WD40™ will destroy the bearings
.
Exterior painted surfaces including the cutting chamber may be cleaned with non-abrasive
household cleaners. The protective hood and touch pad control panel should be cleaned using
mild soap and water applied with a soft cloth.
Automatic Blade Dressing
The Automatic Blade Dressing system uses a fine-tooth shaft for advancing the Dressing Stick,
giving maximum cleaning cuts from the stick. Periodically this fine-toothed shaft will need to be
cleaned and lubricated.
Cleaning the Automatic Blade Dressing shaft
1. Turn off the IsoMet 4000.
2. Open the hood.
3. Pull the T-mount out of the housing.
4. Using the supplied cleaning brush, clean the shaft thoroughly and lubricate with a light oil.
Do not
use WD40™.
5. Carefully align T-mount and push it back into the housing.
