25
MA112680_39.3
[Original Instructions]
4/2014
Maintenance
The IsoMet 4000 Linear Precision Saw will continue to perform at optimum levels with proper care, daily
cleaning, and general maintenance.
The protective hood and touch-panel control pad should be cleaned using mild soap and water applied
with a soft cloth.
Do not
use ammonia-based cleaners, i.e. Windex
®
. Cloudiness and cracking can occur.
Exterior painted surfaces, including the cutting chamber, should be cleaned with a non-abrasive
household cleaner.
Internal Coolant/Lubricant Recirculating System
Discard and replace the coolant and/or lubricant when it becomes contaminated with abrasive
residue or debris. Follow the mixing directions for the Buehler recommended cutting fluid, as
indicated on the cutting fluid container.
Draining the Coolant
While the machine is not in use, remove the coolant tank, remove the lid, and pour the coolant in
an appropriate container.
1. Lift the hood.
2. Pull off the Coolant Tube fitting and hold it over a container.
3. Press the PUMP MOTOR button to the ON position.
4. Let the pump run until the cooling tank is empty.
5. Turn the pump off and remove the tank for cleaning.
Do not run the pump dry for more than 30 seconds.
6. Wipe out the tank, clean the screen, replace the screen, and place the tank back into the
machine.
7. Press the PUMP MOTOR (see page 10) button to ON to run the coolant through the pump
before use.
CAUTION
!
Equipment Damage. Do not install the tank without the internal round screen. This
prevents debris from entering into the pump.
