background image

on           go             master            bass           mid             treble             drive           rhythm 

off          rest        pull channel                  pull modern                                               pull brite             footswitch

                input

Superdrive 18 Series II Manual

Thank you for purchasing the finest tube amplifier in the business. We appreciate your support and 
look forward to providing you with years of trouble free service.  Before we get into the features of your 
amplifier, we would like to note that tube amplifiers require a little bit of care and maintenance that we 
would like to share with you. When you first turn on your amplifier remember to leave it on rest for 
at least 30 seconds before turning it to go.  This will give the tubes plenty of time to warm up and will 
extend tube life. The chassis is built out of aluminum which is a conductor of heat.  It may feel warm to 
the touch, but no need to worry.  

Check to make sure that the impedance switch is set to the correct ohmage for your cabinet. Improper
loading may cause excess tube and transformer wear and eventual failure.  Use high quality speaker and guitar
cables to ensure maximum performance.  For tube related problems, we’ve included a trouble shooting
section on page three off your manual.  

Now,  lets take a look at the features of your amp by starting with the front panel.  

 

On / Off - 

            Power on and off switch

 

Go / Rest -

           Standby control

 Master  -  

            Controls the overall volume of your amplifier.

 

Pull channel -

   Access the hi gain channel by pulling out,  for rhythm channel leave pushed in 

 

Bass -  

                 Controls the bass frequency of your amp

 Mid -  

                   Controls the mid range frequencies of your amp by adding and cutting from bass and treble

 Pull Modern -

   Reduces mids while increasing bass and treble frequencies so that your amp has more presence

 

Treble - 

              Controls the treble frequency’s of your amp.

 

Drive - 

                Controls the overall amount of distortion of your hi gain channel

 

Rhythm -

            Controls the gain and volume of your clean channel

 

Pull Brite - 

        Adds treble boost to your rhythm channel. 

 

Input -  

               Instrument input

 

Footswitch -

     1/4” jack for footswitch that channel switches your amp between clean and hi gain channels.

     

 
  

                   pg1

Отзывы: