BuckMaster MODEL 20, Руководство по установке

Страница: 36 / 64

Page 34
4. Using penetrating oil, generously lubricate four (4) bolt threads holding catalyst housing in place. Allow to
penetrate.
5.
Using a 9/16” wrench or 9/16” socket, loosen four (4) bolts and remove catalyst housing (drop down) and
place in a suitable work area.
6.
Using needle nose pliers, grasp front edge of stainless steel “can” which houses a catalytic element and pull
upward.
7. Using a small putty knife or scraper, remove any gasket that may have adhered to catalyst housing.
8.
Obtain new catalysts and wrap the stainless steel “can” with interam gasket and tape ends together using
scotch tape or masking tape.
9. Insert new catalysts into catalytic housing and push down until they are seated on top of stainless steel wire
mesh supports.
10. Reinstall catalyst housing into stove and secure in place with bolts.
11. The stove is now ready for use.
DOOR GASKET REPLACEMENT (Cold Heater)
To replace deteriorated gaskets, following steps must be taken to ensure proper installation of gaskets.
1. Obtain proper gaskets and silicone glue from your local dealer.
2. Using pliers, remove any worn and deteriorated gaskets.
3. Using a scraper, wire brush and sandpaper or steel wool, clean glue and gasket residue from door frame.
4. Measure and cut gaskets to length. Care should be taken not to stretch gaskets. What you want is a full and
loose gasket weave after attachment to framing.
5.
Obtain silicone glue and run a 3/16” bead inside door frame.
6. Obtain gasket (s) and place in gasket channel areas. Use a technique which assures that gasket is applied in a
loose like manner. DO NOT STRETCH GASKETS.
7. After gasket (s) are applied to glue, use your finger and go over all gasket gently pressing gasket to the
channel. Use same pressure against gasket so that final result is an evenly applied gasket.
8. Leave door open and allow at least one hour for glue to dry.
9. Once gaskets are checked, heater is ready for use.
10. This should be done annually. Allowing gaskets to deteriorate can cause over-firing and shorten burn time.
ROPE GASKET
SILICONE
2” X 2” X 7” STANDARD 25 CELL
LONG LIFE CATALYSTS
1/16” THICK INTERAM GASKET AND
STAINLESS STEEL CAN (2 EA.)
1/16” THICK INTERAM GASKET
(LAP ENDS 1/4” AND TAPE)
APPLY 1/16”X 1/2” FIBERGLASS
GASKET COMPLETELY AROUND
SEALING LIP.
CATALYST HOUSING
(STEEL OR CAST IRON)
FRONT
BOLT HOLES