BÜCHI Labortechnik AG
Operation | 6
Operation Manual Rotavapor® R-300
55/116
on
Lift set
max.95°
46
°C
50
°C
Set
STOP
3
Fig. 35: Heating bath display
3
"Lift set" indication for depth stop
ð
The display of the heating bath base shows "Lift set" (3).
u
To delete a depth stop, press and hold the Set button (1) for at least three
seconds until "Lift set" disappears from the display.
The position of the rotary drive unit is indicated on the display of the Heating Bath
B-300 Base and the Interface I-300/I-300 Pro as follows:
If no depth stop has been set, the distance of the lift from the top end is indicated,
starting from 0 mm as the highest position. Any position below that is indicated
accordingly by a negative figure.
If a depth stop has been set, the distance of the lift from the bottom end is
indicated, starting from 0 mm as the lowest position. Any position above that is
indicated accordingly by a positive figure.
NOTE
2 different speeds: the lift moves down quickly until it is 2 cm from the depth stop; it
then moves slowly over the last 2 cm to the depth stop.
Manual height adjustment
2
1
Fig. 36: Rear view of Rotavapor
1
Handle on Rotavapor arm
2
Stop screw
