btsr ULTRAFEEDER, Руководство по эксплуатации

Страница: 41 / 81

Operation
ULTRAFEEDER - 3-1 -
3 – OPERATION
Operating Characteristics of ULTRAFEEDER Devices
For programming and control of ULTRAFEEDER devices, 3 push-buttons, 2
signaling red LEDs and a LCD display are available to the operator.
1. RED LEDs (Front side and Read side)
Red Led on the front side of device.
Red Led on the rear side of device.
For the correct interpretation of the indications provided by the Leds, please refer
to the table shown on page 4.1.
2. E PUSH BUTTON (ENTER)
Press and hold down this push-button to gain access to the advanced device’s
programmable functions.
During the programming phase, press it to
confirm the displayed parameter.
Pressing and holding down this push-button for about 3 seconds on particular
parameters, you will have the possibility to
enable/disable the corresponding function.
3. - PUSH BUTTON (RESET)
Press this push-button to cancel possible error signaling on ULTRAFEEDER
display
(red LED flashing). During the Programming phase, press it to decrease
the value of displayed parameter. During the Control phase, without an alarm
condition in progress, this button allows you to display the device’s internal
temperature.