26
Living Now with Netatmo
Installation Manual
Dissociate a wireless control from the connected devices
Reset to the factory settings
1. Press at the same time the two pushbuttons of the control to dissociate until the LED turns
orange.
While the LED is orange release the pushbuttons.
1. Remove the plate and the cover to access the reset button.
2. Press and release the two control keys at the same time.
The LED will start flashing green, then turns blue, and then turns off.
1
1
Procedure for wireless controls K4003CW – K4570CW – K4003DCW – K4574CW – 3577C wireless
light control;
or
K4027CW wireless shutter control
2
2
Warning:
this procedure completely dissociates the device from the smart electric system.
Warning
:never reset the K4570CWIN/OUT Master control; in case of reset, start the association with the
zigbee network by quickly pressing the Gateway reset pushbutton, and then press and release a key of
the K570CW control and wait for the association to take place (the control key flashes green for a few
seconds and then turns off).
K4003CW – K4003DCW – 3577C wireless light control
or
K4027CW wireless shutter control
1
