Page | 6
Embedded User Menu
The button used to operate the menu is located on the controller board inside the display
housing and marked
B1
. To access, unscrew the two philips head screws and slide out the
controller board drawer. Once you have finished the configuration, push the drawer back,
making sure that the seal is not compromised.
Fig. 1
Location of button B1
The user menu has the following options:
▪
info,
▪
proto,
▪
custm,
▪
reset.
To activate a specific option, keep the button pressed until this option appears on the screen
("info", "proto", "custm" or "reset"). The option is entered after releasing the button when its
name is being displayed. If the button is released when the screen is blank between two
consecutive options, the display will return to its normal operation.
"
info
" option allows you to display the device software version and the network layer settings (IP
address, network mask, communication port for the WagSet RM software and communication
port for the weighing terminal).
“
proto
” option allows you to select the display communication protocol to work with the selected
weighing terminals (Tab. 1). You can change the protocol by short pressing the button. Saving
the selected protocol is accomplished by long holding down the button (until the message
