40
If you experience any problems, please call the Helpline on Freephone 0800 218 2182* or visit www.bt.com/producthelp
Using additional handsets
You can use up to five BT Diverse additional handsets with your
BT Diverse 7410 Plus base to extend your phone system without
needing to install extension sockets for each new phone.
Your BT Diverse 7410 Plus handset can also be registered to up to
four other bases. You can then select the base you would prefer
to use.
If you have purchased an additional handset you must register
it to your BT Diverse 7410 Plus base before it can be used. The
batteries must be fully charged for 24 hours before you register it.
You may be able to register other DECT handsets to your BT
Diverse 7410 Plus. Compatibility of products may vary and the
number of features available may be reduced in doing so.
Easy registration of a new additional Diverse handset
To use easy registration a new handset must be used and the
base must have the PIN code 0000. (If the base PIN has been
changed then the longer registration procedure on the following
page will need to be followed).
1
. The display will show
Please
Register
and once the handset
has been fully charged for 24 hours, press
Reg
(left soft key).
2
. The display will show
Press
and
Hold
Base
Find
Key
. The
button is located on the Diverse base underneath where
the handset sits. Press and hold the
button on the base for
approximately 8 seconds until the base beeps, then release.
3
. Immediately, press
OK
on the handset to confirm. The base will
go into registration mode for 90 seconds and will beep when
registration is successful. The handset will automatically be
assigned the next available handset number and registration is
now complete.
If registration is not successful first
time, please repeat the process again
in case the base registration period
ran out of time.
If there are already 5 handsets
registered to the base, the
registration will fail. You must
de-register another handset before
you can register the new one.
If your BT Diverse 7410 Plus handset
is registered to more than one base,
you can select which base to use,
see page 25.
If you have a handset registered
to more than one base and then
de-register it from one of them
you will need to re-select which
base to use. Until the base is
selected the handset will display
Please
Register
.
Registration of handsets can only take
place while the base is not engaged
on another call.
