Real Freedom | Receiver Product Manual
34 of 51
Video issues
The following table contains information to help you troubleshoot video issues.
Table 20: Troubleshooting video issues
Symptom
Possible cause
Actions
No video displayed.
No video input to the camera
back transmitter.
•
Check the camera back transmitter
connections.
Incorrect video source.
•
Ensure that the video source is set based on
the input cable. For example, if the cable is
connected to ‘RF’, set the video source to
‘RF’.
Mismatches frequencies.
•
Ensure that the transmit and receive
frequencies for the camera back transmitter
and receiver are the same.
•
You can link the receive and transmit
frequency to keep them at the same value. If
you then change the receive or transmit
frequency, the remote transmitter frequency
or receive frequency automatically changes
to the same value.
Camera transmitter issues
The following table contains information to help you troubleshoot camera transmitter issues.
Table 21: Troubleshooting camera transmitter issues
Symptom
Possible cause
Actions
No remote control from
receiver.
Incorrect configuration or no
control data sent.
•
Check the receiver is correctly configured
and connected to the RCP.
•
Remote control is only possible when data is
active, and the receiver is properly coded
and connected to the client RCP.
Connection error.
Frequency settings do not
match.
•
Verify that the frequency settings on the
receiver and transmitter match.
•
You can link the receive and transmit
frequency to keep them at the same value. If
you then change the receive or transmit
frequency, the remote transmitter frequency
or receive frequency automatically changes
to the same value.
Dark screen/display on
the camera back
transmitter.
The display has ‘timed out’.
•
Touch all four quadrants of the screen within
one second; trace a U or X pattern on the
display to wake. You can disable the screen
timeout from the
camera back transmitter’s
Settings
page.
•
The screen backlight is set too low. Adjust
the screen backlight from the camera back
transmitter’s
Settings
page.
