BSi IRX-3811, Руководство по эксплуатации продукта

Страница: 27 / 51

Real Freedom | Receiver Product Manual 27 of 51
Audio settings
The audio settings allow you to check the peak levels on each audio channel and to change the analog
audio gain on the transmitter. The peak levels on the four audio channels also displays on the
Audio Status
page.
From the main menu, select Audio and configure as follows.
Table 13: Audio settings
Setting Description
Audio Tx Gain Sets the audio transmit gain for each channel. Range -20 dB to +20 dB.
Note that this controls the analog (not embedded) audio gain at the
transmitter when under
‘BSI control’. This value corresponds to a value
that can also be set manually on the transmitter. If the transmitter is
configured as
‘BSI control’, then this overrides anything that you may set
on the transmitter.
Audio Output Defines which audio channels will be output onto the two rear panel audio
XLR connectors.
Select ‘Off’ if those outputs need to be muted because they are connected
to something downstream.
Audio Latency Sets the required audio latency.
Note that this is an advanced setting which should not be changed under
normal circumstances. If you are using third-party equipment, consult BSI
Technical Support who will advise on the correct settings.
Audio PID Selection Defines the packet identifier (PID) to identify the audio content stream on
channels 1&2 and on channels 3&4.
Note that this is an advanced setting which should not be changed under
normal circumstances. If you are using third-party equipment, consult BSI
Technical Support who will advise on the correct settings.
Other settings
Once you have defined the main configuration settings, you can use the other options on the Settings sub
menu to:
•
Set camera, RF and ASI port names.
•
Set the system time and date.
•
Configure input tallies and DB9 connector logic.
Camera and RF names
You can name the camera, RF ports and ASI port to help to identify the camera and the locations of the
downconverters attached to the receiver’s RF ports. These names appear on the
Receive Status page. The
name and camera number (allocated in the Camera Ctrl configuration settings) also appear in the top left of
the receiver screen.
From the main menu, select Settings , then select Cam & RF Names and configure as follows.
Table 14: Camera and RF names
Setting Description
Camera name, ASI name,
RF names Assigns a camera name, ASI name, and/or RF names.
To make this easier, plug a USB keyboard into the USB port on the front
of the receiver and type the required names. If you are accessing the
receiver menus using a web browser, you can use your computer’s
keyboard to type the required names.