Real Freedom | Receiver Product Manual
17 of 51
Since systems are typically installed in shared circuits, be aware of how many units are plugged into the
source and the total current draw.
WARNING:
Connect the product only to a power source with the specified voltage rating.
AC SUPPLY
When powering from an AC supply, you must connect the receiver to the mains supply using the IEC mains
cable provided.
The receiver does not include an AC power switch and therefore the mains plug is to be used as the
disconnect device. Position the receiver to allow easy access to the plug socket.
DC SUPPLY
When powering from a DC supply, connect the receiver to the supply using a DC power cable (not supplied).
The DC power supply must have the following characteristics:
Table 4: DC Power supply characteristics
Characteristic
Specification
Output voltage
10 to 36 V DC
Output power
>100 W continuous
Connector
4-pin XLR female connector (for example, Neutrik NC4FX)
Cable
Twin core with minimum 2.5 mm
2
copper conductors
The receiver does not include a DC power switch and therefore the DC power cable (XLR-4 female plug) is
to be used as the disconnect device. Position the receiver to allow easy access to the plug socket.
Connect Real Freedom components
Before powering the receiver and setting the configuration parameters for the system, you should connect
the various Real Freedom components. The following diagram shows the components in a simple Real
Freedom system.
Figure 8: Components of a typical Real Freedom system
