Real Freedom | Receiver Product Manual
15 of 51
•
The rack should be a minimum of two inches (5.1 cm) away from the receiver, and the back of the rack
shou
ld be a minimum of four inches (10.2 cm) from the receiver’s back panel.
•
Since there is no power button (on/off switch) on the receiver, ensure that you have access to the rear of
the rack or leave a sufficient wire management loop to pull the unit out from the front of the rack.
Mounting procedure for a single receiver
To mount the receiver, you will require 2RU (3.5 inches, 89 mm) of vertical rack space and a Real Freedom
Single Receiver Rack Mount Kit (BRK-0005-00).
1. Attach the
Bracket Fixing 2U
to each side of the receiver using four M5 x 12 Phillips screws.
2. Attach the
Rack Mount Spacer
to the
Bracket Fixing 2U
using two M5 screws.
You can install the spacer on the left or right side of the receiver. If you are installing the receiver in a
half-width rack, no spacer is required.
3. Install the receiver at the desired location in the equipment rack and secure to the vertical uprights using
four rack screws.
