Pg. 40
6. Test Speed again
[IF USING SPEED SENSOR]
2. Next select "Bike Settings" and enable either Bike 1 or 2
3. Under the selected Bike profile, select Spd Source
4. Set Priority 1 to "Speed" or "Speed/CAD" (if using a cadence sensor), Priority 2 to "Speed" or "Speed/CAD"
(whichever was not selected as priority 1) and Priority 3 to GPS.
5. Test Speed again
Changing Settings on Device
1. Power on Device and navigate to the "Bike Profile" (please refer to the user manual for more information)
[IF USING GPS]
2. Select Bike 1 or 2 (whichever one is currently set)
3. Under the selected Bike profile, select Spd Source
4. Set Priority 1 to "GPS", Priority 2 to "Speed" or "Speed/CAD" and Priority 3 to whichever has not been selected.
5. Test Speed again
[IF USING SPEED SENSOR]
2. Select Bike 1 or 2 (whichever one is currently set)
3. Under the selected Bike profile, select Spd Source
4. Set Priority 1 to "Speed" or "Speed/CAD" (if using a cadence sensor), Priority 2 to "Speed" or "Speed/CAD"
(whichever was not selected as priority 1) and Priority 3 to GPS.
5. Test Speed again
Ensure that the correct Bike profile is selected before a workout. If switching between Speed Sensor and GPS, it is
important to change profiles before the workout, ensuring the right priority settings are set up.
If speed still does not appear if you have any questions, please contact
support
_
XIII. Altitude Troubleshooting
For applicable Bryton Devices, altitude measurement is done through a Barometric Altimeter, which measures the
changes in air pressure in order to determine changes in altitude. Because of this, readings may be different from
map-based readings (such as Strava) and result in slightly higher/lower readings.
A. Causes of Inaccurate Readings:
- Incorrect Starting Reading/Current Altitude (see Calibration)
- Changes in Air Pressure
- Changing Weather Conditions
- Changes in Air Temperature
- Covering Device in a Case (see Device Case)
Содержание Aero 60
Страница 1: ...Version 1 00 00 01 Troubleshooting Guide...
