off
on
0,25s
0,25s
0,25s
0,25s
0,25s
4s
Figure 4: Flashing pattern in status Initialization Foreign-/Living Object Detection
In practice this initialization is carried out by making sure that there is no object lying on the GPM surface. Then
place an approx. 5cm large piece of metal (e.g. 5cm large steel disk, beverage can, etc.) on the GPM and remove
it again after 6-9sec. The initialization of the foreign-/living object detection is possibly required
•
after the GPM is switched on or after a mains failure,
•
during the operation
7.3.1.3 Status: Not Connected
The GPM is in this status, when the power supply for the GPM has been switched on, the initialization of the
foreign-/living object detection has already been performed, but there is not yet any vehicle nearby, which is
suitable for charging with the GPM.
off
on
2s
0,1s
0,1s
2s
Figure 5: Flashing pattern in status Not Connected
7.3.1.4 Status: Connected
If a suitable vehicle (with CPM) is configured for charging with the GPM and if this vehicle is near the GPM, then a
WLAN connection is established between CPM and GPM. The charging process is controlled automatically from
the vehicle via this WLAN connection.
off
on
Figure 6: Flashing pattern in status Connected
Operation Manual
Inductive Charging System
ICS115
32