Brusa BDC546, Технические данные и запуск

Страница: 31 / 87

31
Technical data
and start-up
BDC546
6.10 Dimensions and installation information
For the installation of the device, the following points must be generally adhered to:

Despite the existing IP protection, the device should only be exposed to environmental influences to the
extent required by the application.

The device may not be installed in the direct vicinity of heat sources (e.g. combustion motor).

The mechanical fastening is to be aligned in such a way that the device is installed in a secured position and
with as few vibrations as possible.

The cable inlets and cooling water ducts should have enough space and must never touch components with
sharp edges.

All cable connections must be secured with strain relief elements near the device (not included in the scope
of delivery).
6.10.1 Fastening points
NOTICE
The housing has been designed for a maximum admissible fastening screw torque of 8 Nm! For
fastening the device at the fastening points, eight M6 screws are to be used and tightened with a
tightening torque of 8 Nm.
1. 8 screws with M6 thread, stud hole with
18 mm depth