Bruker SamplePro hr-MAS, Руководство пользователя, Страница: 61 / 82

61
Z31914_00_01
Preventative Maintenance
11.2 Cleaning the Outside of the SamplePro hr-MAS and Units
Clean the outside of the SamplePro hr-MAS chassis and units with a soft, lint-free cloth
dampened in water.
• Do not use any detergent or other cleaning solvents.
• Only use water or neutral cleaning fluids.
• Usage of volatile cleaners like thinner or benzine may damage the surface of the
unit.
11.2.1 After Cleaning
Wait until the unit is completely dry before you reconnect the line plug.
11.2.2 Other Cleaning Operations
For all other cleaning operations contact your authorized service station for advice and
support. It may be necessary to send in the probe for a cleaning service, if cleaning of
the probe becomes necessary due to excessive background signal. No special precau-
tions have been taken in standard BRUKER probes to avoid contamination from a bro-
ken rotor. BRUKER accepts no responsibility for any damage which may occur when
samples are used containing radioactive or other hazardous materials.
In case of an accident with toxic, radioactive, explosive or biologically active substances,
the probe and associated equipment must be cleaned in such a way that there is no lon-
ger any danger in any form, especially for all uninformed personnel. If a probe has to be
cleaned of all remains of a substance for safety reasons, contact your authorized service
station for advice and support, as there is no standard cleaning procedure that is appli-
cable for all probe types. Note that in serious cases it may be necessary for the cus-
tomer to properly dispose of the probe and replace it with a new one.
11.3 Cleaning the Robot Barcode Reader
Clean the robot barcode reader once a year with warm water and a damp lint-free cotton
cloth or towel.
Note : Excessive dust or dirt at the lens surface of the optics reduces the optics recogni-
tion performance. Keep these surfaces clean.