© Brüel & Kjær Vibro
● C106834.002 / V06 ●
Page 37 of 110
Technical alterations reserved!
Brüel & Kjær Vibro
│
Instruction VC-1800 Series
Installation and Operation of VIBROCONTROL
18xx
EN
UNRESTRICTED DOCUMENT
- Alarms
The user can set four (4) alarms within the values Y1 and Y2:
-
Danger alarm: Whenever the Y value exceeds a maximum value.
-
Alert alarm: Whenever the Y value exceeds a maximum value that requires action.
-
Below Alert alarm: Whenever the Y value drops below a minimum value that requires action.
-
Below Danger alarm: Whenever the Y value drops below a minimum value.
Enabling of the "Safety Monitor" function.
When this function is selected, the safety relay is triggered every time Danger alarm is exceeded or
the value drops below Danger alarm.
6.13 Rotational Speed Sensor (Tacho) Input
General settings of the Tacho input under "Speed Sensor: Name"
The parameter settings of the Tacho input are defined in the Speed Sensor setup. The current
parameters of the Tacho input (Speed Sensor setup) can be set under "Edit / Speed Sensor.
To do this the function must first be set to "Enabled." The actual parameter settings of the Tacho
input (rotational speed encoder setup) are made under "Edit/Rotational speed encoder": Name,"
which is divided into four areas.
•
Properties:
Under "Properties" first define the kind of rotational speed sensor.