VIBROTEST 60
Field Balancing
_________________________________________________________________________________
© VTEST60E July 2013 V4.46ff
C102 853.002
Page 109 of 168
7.2.3 Softkeys
According to the instrument status additional softkeys are active
during balancing:
+/-
Allows you to select between „Add weights„ and
„Remove weights„ during unbalance correction.
ADD
In the main menu:
All correction weights attached to the rotor during the
current balancing procedure can be combined into
one single correction weight. VIBROTEST 60 calcu-
lates the resultant weight and its correct location.
In the test weight entry menu:
The selected test weight is added to the existing test
weight.
CR=IR A new balancing procedure is started after the Check
run. The result of the Check run is used for the Initial
unbalance run in the new procedure. The data from
the previous balancing procedure is deleted.
AVERAGE Switching the averaging function On/Off.
RESET Deletes all information from the measuring runs of
the entire balancing procedure.
SELECT The marked measuring run is selected.
START The measurement is started. „STOP„ is displayed
and the channel number flashes to indicate that the
measurement is in progress.
STOP
The measurement is stopped. „START„ is displayed
to indicate that the measurement has stopped.
SUBST The entered test weight replaces the existing test
weight.
Содержание VIBROTEST 60
Страница 1: ...Technische Dokumentation Technical Documentation Dokumentation Technique VIBROTEST 60 C006389 01...
Страница 4: ...Technische Dokumentation Technical Documentation Dokumentation Technique VIBROTEST 60 C006389 01...
Страница 172: ...Anhang EG Konformit ts Erkl rungen VIBROTEST 60 Page 168 of 168 C102 853 002 VTEST60E July 2013 4 46ff...
