BRP Johnson BJ25E4SUC, Руководство по обслуживанию, Страница: 51 / 265

MAINTENANCE
INSPECTION AND MAINTENANCE SCHEDULE
49
3
Operator’s Guide, review
3
Timing belt Replace every four years
Valve tappet clearance, inspect
(3)
3 3
Driveshaft splines, inspect and lubricate E
3
Fuel system components, inspect and repair leaks
(3)
3 3
Carburetor, inspect
3
Breather line, replace
3
Fastener inspection, tighten loosened components
3 3
Starter pinion shaft, inspect and lubricate F
3
Electrical and ignition wires and connections, inspect
3
3
Gearcase lubricant replace B
3 3
Powerhead synchronization and linkage, inspect
(3)
D
3 3
Gearcase lubricant, inspect fill level and condition of lube B
3
Propeller shaft, inspect and lubricate D
3
Spark plugs, replace
(3)
3
Decarbonize G
3
Water pump, inspect and replace
3
(1) Also recommended at 10-Hour Inspection
(2) Replace every 100 hours or annually if Ultral 4-Stroke oil is not used.
(3) Emission-related component
A Evinrude/Johnson Anti-Corrosion Spray or Evinrude/Johnson “6 in 1” Multi-Purpose Lubricant
B HPF XR Gearcase Lubricant
C Power Trim/Tilt and Power Steering Fluid
D Triple-Guard Grease
E Evinrude/Johnson Molylube
F Starter Bendix Lube Only
G Evinrude/Johnson Engine Tuner
H Evinrude/Johnson Ultra 4-Stroke synthetic blend oil
Engine Maintenance and Inspection Schedule
Description
Engine
Care
Product
Frequency
Each Use 10-Hour Inspection Every 50 Hours or 6
mon
ths
Every 100 Hours or An
nually
Every 200 Hours or Bian
nually