BRP Evinrude E-TEC, Руководство пользователя

Страница: 322 / 364

322
Manual Starter
Recoil Starter Assembly
Install the rope guide and pulley support to the
starter housing. Tighten the screws securely.
If removed, install the starter handle bracket to the
starter housing. Tighten screws securely.
Tie a knot in one end of the starter rope. With the
starter housing upside down on a bench, wind the
pulley counterclockwise until the rewind spring is
tight.
Back off the rewind spring until the rope cavity of
the pulley is aligned with the rope guide. Thread
the starter rope through the pulley, rope guide,
and outlet in the starter handle bracket.
Seat the knotted end of the starter rope in the pul-
ley. Tie a slip knot in the starter rope to hold rope
in position.
Apply Triple-Guard grease or Lubriplate 777 to the
handle end of the starter rope. Using Starter Rope
Threading Tool, P/N 378774, thread the starter
rope through the handle.
Press the starter rope into the channel of the rope
anchor, with end of starter rope firmly against end
of channel. Press the anchor into the handle.
Check operation of the starter pawl when the
starter rope is pulled out. The starter pawl should
extend when the starter rope is pulled and retract
when the starter rope recoils.
1. Rope guide
2. Pulley support
007854
1. Starter handle bracket 002517
1
2
1
COA1373
007858