BRP Evinrude E-TEC Series, Руководство по обслуживанию, Страница: 37 / 342

35
ROUTINE SERVICE
LUBRICATION
2
and new seal. Tighten plugs to a torque of 60 to
84 in. lbs. (7 to 9.5 N·m).
IMPORTANT:
The recommended gear lubri-
cants are formulated for marine applications. Do
not use automotive gear lubricants, engine oils, or
any other oil or grease.
Trim and Tilt
Check reservoir fluid level at least every three
years or 300 operating hours.
•
System capacity is approximately 15.2 fl. oz.
(450 ml).
•
Tilt the outboard and engage the tilt support.
•
Remove filler cap and check fluid level.
•
Single Ram System –Add Evinrude/Johnson
Biodegradable TNT Fluid, as needed, to bring
level to the bottom of the fill plug threads.
Install the filler cap and tighten to a torque of 45 to
55 in. lbs. (5 to 6 N·m).
•
Disengage tilt support.
•
Cycle the unit at least five complete cycles to
purge all air from the system. When cycling the
unit, hold the trim switch ON an additional 5 to
10 seconds after the unit reaches the end of its
travel before activating the switch in the oppo-
site direction.
1. Lubricant level plug
2. Lubricant drain/fill plug
007270
CAUTION
Correct fluid level must be maintained to
ensure operation of the impact protection
built into the unit.
1. Tilt support bracket 007636
1
2
1
Single Ram System
1.
Filler cap
008018
1