BRP Evinrude E-TEC Series, Руководство по обслуживанию, Страница: 259 / 342

257
GEARCASE
BEARING AND SEAL REMOVAL
12
Pinion Bearings
Assemble the following components from Univer-
sal Pinion Bearing Remover and Installer,
P/N 5005927.
Place the tool in gearcase. using a mallet, drive
the pinion bearings into the gearcase propeller
shaft cavity. Discard the bearings.
Forward Bearing
Use Slide Hammer, P/N 432128, and Bearing
Puller, P/N 432130, to remove the forward bearing
cup from the gearcase.
Secure the puller jaws into grooves behind the
cup. Use Wrench, P/N 334359, to hold the puller
while tightening the jaws.
Shift Rod Bushing and O-ring
Position Shift Rod Bushing Remover, P/N 327693,
under the shift rod bushing.
Thread the adapter of the Slide Hammer,
P/N 391008, in the slide hammer. Place the
adapter through the shift rod bushing and thread
into the remover tool.
Remove the handle from the remover tool. Then
remove the bushing from the gearcase.
Once the bushing has been removed from the
gearcase, examine the bushing for damage. If
damaged, replace the bushing on reassembly.
Remove and discard the O-ring(s) and washer
from the bushing.
1. Rod, P/N 326582
2. Pilot Plate, P/N 326583
3. Remover and Installer, P/N 326577
4. 1/4-20 x 1/2 in. hex head screw
5. 1/4-20 x 11/4 in. hex head screw
6. 1 in. O.D. flat washer
CO3125
1. Bearing puller
2. Wrench
21789
6
5
4
2
1
3
2
1
1. Adapter
2. Shift rod bushing
3. Remover tool, P/N 327693
DRC1505
1
2 3