BRP E 250 L HO AG B, Руководство по обслуживанию

Страница: 38 / 460

38
Routine Service
Before Start-Up
Before Start-Up
Gearcase Lubricant
With outboard vertical, check the gearcase lubri-
cant level:
•
Inspect the lubricant level in the lubricant reser-
voir.
•
Lubricant level should be between the marks as
shown.
Add HPF PRO gearcase lubricant if needed.
2-Stroke Engine Oil Level
Make sure the outboard is in the vertical position
when checking oil level. Use the digital gauge or
display to check the oil level. Make sure the on-
board oil tank contains an adequate supply of the
correct lubricant for the outboard. Refer to
Rec-
ommended Lubricants on p. 192.
Trim and Tilt Fluid
The trim and tilt system is filled, tested and sealed
at the factory. It is
NOT necessary to check fluid
level.
Check the fluid level ONLY if the trim and tilt is
NOT operating normally:
•
Tilt the outboard to the full UP position.
•
Remove filler cap and check fluid level.
•
Add Power Trim/Tilt Fluid, P/N 767969 , as
needed, to bring level to the bottom of the fill
plug threads.
1. Lubricant reservoir 009140
Lubricant Level
1. Maximum
2. Minimum
009141
1
1.5 in.
(38 mm)
{
1
2
{

CAUTION
Correct fluid level must be maintained to
ensure operation of the impact protection
built into the unit.
1. Filler cap 009127
1