BRP E 250 L HO AG B, Руководство по обслуживанию

Страница: 309 / 460

309
Stern and Swivel
DPS Module Service
13
DPS System Calibration
Steering Pressure Sensor Calibration
(AFA and Newer Models Only)
IMPORTANT:
Calibrate the pressure sensor
when:
•
replacing a DPS module
•
replacing a steering pressure sensor
Connect a piece of tubing to each bleed valve.
Insert the open end of the tubing into a container
appropriate for collecting hydraulic steering fluid.
Open the both bleed valves at least one-half turn
to relieve pressure on the hydraulic steering sys-
tem.
Wipe up any spilled steering fluid with shop tow-
els.
Use Evinrude Diagnostics software v 6.1 or higher
to calibrate steering pressure sensors.
Connect the MPI-2 and adapter cable to the lap-
top and the
NMEA 2000 network. Turn the key
switch to the ON position, then start the diagnostic
program.
After the program connects to the network, select
from the device list the
Engine Controller (EMM) .
Then select the Power Steering button.
1. Select Enable Calibration , The power steering
pump is disabled while in calibration mode.
2. Select Zero Pressure Sensors . The button will
deactivate while setting the ZERO point. Wait
for the button to activate BEFORE continuing.
3. Select Disable Calibration to save the setting
and re-enable the power steering pump.

WARNING
The DPS system of AFA and newer outboards
REQUIRES calibration when:
•
installing multiple outboards
(initial installation)
•
replacing a DPS module
•
replacing a steering pressure sensor
•
replacing a steering position sensor
Failure to complete DPS system calibration
can cause damage to the tie bar(s) and/or the
transom of the boat due to overloading.
1. Bleed valves 009396
ENVIRONMENTAL NOTE:
Dispose of contaminated shop towels according
to local environmental regulations.
1
1
1. Enable Calibration 009397
1. Zero Pressure Sensors
2. Disable Calibration
009398
1
2
1
2