BRP E 250 L HO AG B, Руководство по обслуживанию

Страница: 306 / 460

Stern and Swivel
Steering Position Sensor Service
306
Turn the steering wheel fully to PORT. While hold-
ing the steering wheel against the stop, observe
Port Pressure . Then turn the steering wheel fully
to STARBOARD. While holding the steering wheel
against the stop, observe
Starboard Pressure .
Pressure should be approximately 1000 psi (6895
kPa) for a standard helm, or 1500 psi (10342 kPa)
for a
Pro-Series or SVS-Series helm.
Steering Position Sensor Test
Use Evinrude Diagnostics software v 6.1 or higher
to observe steering angle while turning the steer-
ing wheel.
Steering Position
Sensor Service
Remove two screws from the sensor and two
screws from the magnet.
Assembly is the reverse of disassembly. Tighten
all screws to a torque of 35 to 60 in. lbs. (4 to 6.7
N·m).
IMPORTANT:
The steering position sensor uses
a clamp-on ferrite suppressor. Remove the sup-
pressor from the old sensor. Install the suppressor
on the sleeve of the new sensor, within 2 to 4 in.
(50 to 100 mm) of the electrical connector.
1. Port Pressure
2. Starboard Pressure
009401
1. Steering Angle 009401
1
2
1
NOTICE
The steering position sensor includes a sen-
sor and a magnet which is a matched set.
When replacing a steering position sensor,
replace BOTH the sensor and magnet.
1. Sensor
1. Magnet
009745
1. Ferrite suppressor 009747
1
2
1
2 to 4 in.
(50 to 100mm)