FLUIDS
Coolant Level Verification
1. Park vehicle on a firm level surface.
2. Pull out the service cover with both hands.
3. Check the coolant level on the right hand side.
Coolant must be visible slightly above the
COLD. level mark.
rmo2013-005-001_a
1. Coolant reservoir cap
4. If required, add coolant until it is visible in the
reservoir slightly above the COLD level mark.
Use a funnel to avoid spillage.
Do not overfill.
5. Stop adding coolant once coolant starts to ap-
pear in the tube.
rmo2014-001-003_a
1. Coolant level reference line (HOT)
6. Reinstall the service cover.
Brake Fluid
WARNING
Avoid contact of brake fluid with skin or eyes
because it may cause severe burns. In case
of contact with the skin, wash thoroughly. In
case of contact with the eyes, immediately
rinse with plenty of water for at least 10 min-
utes and then consult a doctor immediately.
NOTICE
Do not overfill brake fluid reservoir.
Recommended Fluid
Use only DOT 4 brake fluid from a sealed con-
tainer. An opened container may be contaminated
or may have absorbed moisture from the air.
NOTICE
To avoid serious damage to the brak-
ing system, do not use non-recommended flu-
ids. Brake fluid can damage plastic and painted
surface. Handle with care.
Brake Fluid Level Verification
1. Park vehicle on a firm level surface.
2. Unlatch and lift the seat.
3. Remove reservoir caps.
rmo2008-001-040_b
1. Brake fluid reservoir caps
4. Check brake fluid level in both reservoirs, near
the back of the seat.
5. Ensure that fluid is above the MIN. mark.
PREDELIVERY
2014-2
25 / 39
