FLUIDS
NOTICE
Other fuel can degrade vehicle per-
formance and damage critical parts in the fuel
system and engine.
Clutch Fluid (SM5 Model)
Recommended Clutch Fluid
Use DOT 4 brake fluid from a sealed container.
An opened container may be contaminated or may
have absorbed moisture from the air.
Clutch Fluid Level Verification
The clutch fluid reservoir is near the reverse but-
ton on the left handlebar.
Check the clutch fluid level as follows:
1. Park the vehicle on a firm, level surface.
2. Set the handlebar straight in order to position
the top of clutch fluid reservoir horizontally.
3. Wipe clean the cap area.
4. Use the Phillips head screwdriver located in the
toolkit.
5. Unscrew cap retaining screws.
rmo2010-001-005
TYPICAL
6. Carefully remove cap. Pay attention not to drop
the cap seal.
7. Look inside the reservoir to see the fluid level.
Check clutch fluid level inside the reservoir:
– The fluid must be flush to the fill level line (pro-
tuberance on the reservoir wall).
rmo2013-003-040_a
FLUID REMOVED FOR CLARITY PURPOSE
1. Minimum
2. Maximum
8. Add recommended fluid as required.
Do not
overfill.
WARNING
Avoid getting brake fluid on skin or in eyes
— it may cause severe burns. In case of con-
tact with the skin, wash thoroughly. In case
of contact with the eyes, immediately rinse
with plenty of water for at least 10 minutes
and then consult a doctor immediately.
NOTICE
Immediately wipe up spills if neces-
sary.
9. Ensure that the seal located inside the cap is
collapsed.
10. Reinstall the cap on the reservoir.
11. Tighten cap screws.
12. Wipe off reservoir if necessary.
Engine Coolant
WARNING
When opening the reservoir, the coolant can
be very hot and spray out if the engine is
hot. In order to avoid getting burned, check
coolant level when engine is cold.
Recommended Coolant
The cooling system must be filled with distilled
water and antifreeze solution (50% distilled water,
50% antifreeze).
For best performance, use
LONG LIFE ANTIFREEZE
(P/N 219 702 685)
.
24 / 39
2014-2
PREDELIVERY
