FLUIDS
rmo2008-002-510_a
TYPICAL
1. Damping pads
4. Secure upper portion of license plate on vehicle
plate support using existing hardware.
5. Squeeze license plate and support together at
each lower corner.
Accessories Installation
1. Install accessories (if any) as per their installa-
tion instructions (included in each kit).
2. Install any other equipment required by law (if
any).
Vehicle Decals
1. Install decals on vehicle according to customer
country language and local legislation.
2. Ensure that the new decals are installed at the
same location and over the factory installed de-
cals.
FLUIDS
General Guidelines
All fluids (except fuel) have already been filled
at factory, it is only necessary to validate them.
However, if refill is needed, refer to the appropri-
ate
ROADSTER SHOP MANUAL
for the proper
procedure.
Fuel
1. Add fuel in the fuel reservoir.
rmo2008-001-016
FUEL RESERVOIR
2. Fill the tank until the fuel level reaches the
higher point of the filler tube.
rmo2014-001-002_a
1. Higher point of the filler tube
Recommended Fuel
Use premium unleaded gasoline. The gasoline
must have the following minimum octane require-
ments.
Use premium unleaded gasoline with an AKI
(RON+MON)/2 octane rating of 91, or an RON
octane rating of 95.
NOTICE
Never experiment with other fuels.
Engine or fuel system damages may occur
with the use of an inadequate fuel.
NOTICE
Do NOT use fuel from fuel pumps la-
beled E85.
Use of fuel labeled E15 is prohibited by U.S. EPA
Regulations.
WARNING
Never top off the fuel tank before placing
the vehicle in a warm area. As temperature
increases, fuel expands and may overflow.
Fuel is flammable and explosive under cer-
tain conditions. Always wipe off any fuel or
oil spillage from the vehicle.
PREDELIVERY
2014-2
23 / 39
