Assembly Instructions
Page 7
Step 3: Attach Rear Panel
Required: (2) 1/4–20 x 3/8” Screws (G), (1) Rear Panel (M)
Note: Do not tighten any cabinet screws completely. Leave at least one full turn on each. After
all the screws have been installed, go back and tighten them fully.
Align the tabs in the rear panel (M) with the square holes in the bottom panel (V), and then slide the
rear panel until the holes in the two panels are aligned. Insert the screws into the aligned holes. (See
Fig. 3)
Fig. 3
Step 4: Attach Side Panel
Required: (8) 1/4-20 x 3/8” Screws (G), (1) Left Side Panel (Z) and, (1) Right Side Panel (P)
Insert the “Tab A” in side panel (Z and P, Fig. 4) into the square hole in the rear panel (M) and push
down. Make sure the tab is locked in place. For each panel, there are four screws to connect the rear
panel and base, two in the rear and two inside the cabinet. Insert the screws into the aligned holes and
tighten them. The two screws inside the cabinet should be engaged first.
Fig. 4
Rear Panel
Two Tabs
Bottom Panel
Left Side Panel
Tab A
Rear Panel
Right Side Panel
Содержание BR4GRILL
Страница 103: ......
Страница 104: ...Distributed By Camp Chef P O Box 4057 Logan UT 84323 Printed in China ...