Toner that doesn’t cost the earth
Printed on recycled paper, using refilled cartridges
www.zinetic.co.uk
email:
INSTRUCTIONS FOR REFILLING BROTHER TN2000/ TN350
TN2000/TN350 COMPATIBILITY:
DCP 7010, DCP 7010L, DCP 7020, DCP 7025, HL 2020, HL 2030/2030B,
2040, 2050, 2070, FAX 2825, IntelliFax 2820, 2920, 2910, MFC 7225N, MFC 7420, MFC 7820.
Toner Low – continue to
print.
Toner light flashes – means
toner low - ignore message
- Keep printing.
Empty and Refill
Toner Light on continuously -
machine will not print – Empty it and
Refill it.
Please read instructions from start to finish, before you start your refill.
1
Switch printer off.
2
Remove cartridge from printer. Place printer
cartridge on several sheets of newspaper.
3
Locate the hopper
cap on your
cartridge. Normally
hidden behind the
label
4
Remove the
hopper cap using
needle nose pliers,
or a flat blade
screwdriver to lever
out the hopper cap.
5 WARNING: You must ensure all toner is
dumped
from your cartridge
before refilling
with
the new toner
.
You must do this every time.
Brother cartridges can leave as much as 30 grams of
waste toner
in the cartridge, while reporting toner
empty/refusing to print. Important - mixing new and
old toner will cause print defects to occur.
Empty in an area
that can tolerate a
toner spill i.e. your
garage.
Toner can be very
messy - empty the
old toner directly
into a bin bag.
6
Shake your bottle
of new toner
vigorously for 30
seconds BEFORE
removing the cap.
Remove the cap and
seal from the bottle
7
Fit the toner
pouring spout
securely to the
bottle.
Spouts are
reuseable
.
8
Insert the spout
into the hole. The
toner will flow out
like water, so take
care not to spill it.
9.
With the spout
inserted –
carefully
“
Upend” the
cartridge and allow
the toner to slowly
pour into the
cartridge.
10
Replace the cap
in your toner
cartridge, using the
new
plug provided.
11 Gently rock the cartridge from side to side to
distribute the toner in the cartridge. Wipe away any
excess toner from around the plug.
Reset the cartridge using the instruction on the
following page. When successfully reset - replace the
cartridge and print some test pages to remove any
excess toner.
