Brother ScanNCut DX, Руководство пользователя

Страница: 37 / 38

36
Sizes of Rolled Material That Can Be Loaded Into the Roll Feeder
Rolled material of the following sizes can be loaded into the roll feeder.
*1
The maximum width of the cutting area is 251.8 mm (9.9"). Certain areas on the left and right of the material cannot be cut.
*2
For material with a paper core
*3
The maximum length (in the feeding direction) of the cutting area is 1,785 mm (70.3"). (For details, see “Continuous Cutting” on
page 22.) If the length (in the feeding direction) of the material remaining on the roll is 305 mm (12") or less or if the material
sheet size is 305 mm x 305 mm (12" x 12") or less, attach it to a mat to feed and cut it.
Blades That Can Be Used
When cutting using the roll feeder (without using the mat), half-cutting is automatically performed. When using the roll feeder, use
the auto blade holder and the auto blade.
When using the auto blade holder and auto blade, perform trial cutting with the same material to be used in your project to check
that the material can be cleanly cut. If automatic half-cutting is not performed correctly, the cutting pressure can be manually
adjusted. For details on adjusting the cutting pressure, see “Changing the Cut Pressure Setting” on page 19.
Scanner Lever Position
When material is fed, it may hit the machine’s feeding mechanism and not be fed correctly. When cutting using the roll feeder, raise
the scanner lever (on the left side of the machine) to “2”.
a Material width
*1
305 mm (12")
b
Roll diameter 39 mm – 115 mm (1.5" – 4.5")
c Outer diameter of paper core
*2
42 mm – 115 mm (1.7" – 4.5")
d
Inner diameter of paper core
*2
39 mm – 115 mm (1.5" – 4.5")
e Thickness of rolled material
*3
0 mm – 21 mm (0" – 0.8")
f
Material thickness (including
backing paper or backing film)
0.21 mm – 0.35 mm
5
3
4
1
6
2