Brother SC-2000, Руководство по обслуживанию, Страница: 108 / 150

IV - 5
Error mode Checking method Cause Action Service manual
A draft sheet or an
ID label is fed, but
no printing is
performed. Is the
connector
of the
thermal
head dis-
connected? YES Disconnected
connector of the
thermal head Connect the
connector of the
thermal head. CHAPTER III
2.17
Reassembly of
the Main PCB
Assy
NO Defective head or
PCB
→
Electronic part
The presence or
size of the holder
can not be
detected. Does the size of a
holder match that of
a stamp to be
manufactured? Incorrect size of a
holder Set a holder
whose size
matches the size
of a stamp to be
manufactured. _
Is the holder set in
the correct position? Holder set in the
incorrect position Set the holder in
the correct
position. _
Non of the above Defective PCB
→
Electronic part
The printing surface
is insufficiently
fused after Is the printing surface
of the holder flawed
or dented? Defective printing
surface of the
holder Engrave stamp
with a new holder. _
engraving stamp.
Is the surface of the
transparent plate of
the xenon unit dirty? Dirty surface of
the transparent
plate Clean the surface
with a soft cloth.
(If the dirt or blur
can not be
removed, replace
the xenon unit.)
_
Is the presser unit set
at a specified height? Insufficient
pressure Adjust the height
of the presser unit
with the setting
presser jig assy
and adjustment
jig. CHAPTER III
2.8
Reassembly of
the Presser Unit
Assy
Non of the above Insufficient light
emitted by the
xenon lamp Replace the
xenon unit. CHAPTER III
1.2
Disassembly of
the Magazine
Tray and the
Xenon Unit
2.19
Reassembly of
the Xenon Unit
Replace the
capacitor box. CHAPTER III
1.5
Disassembly of
the Capacitor
Case
2.16
Reassembly of
the Capacitor
Case