How do I set the Label Peeler?
If the label peeler is used, printed labels can be automatically peeled off their backing paper before they are fed out of the media exit. This is useful when printing large quantities of labels and apply them at an
inconsistent pace, because the peeler sensor prohibits printing the next label until it is removed from the printer.
To set the Label Peeler, please follow the steps or click on the image to play the video instructions below:
Movie: How to set the Label Peeler
*The video clip is being streamed from YouTube.
How to use the buttons:
Start the video
Skip the video
Stop the video
Restart the video
1. Push the cover open lever to open the RD Roll compartment cover.
1 Cover open lever
2. Push both sides of the label peeler towards the rear of the printer. The peeler will move up and away from the printer.
Then, fully pull out the peeler away from the printer until the
marks on the peeler are visible as shown.
The paper can be pulled out in two stages. Be sure to pull out the peeler completely.
3. Peel off the first label of the RD Roll. Then, insert the RD Roll so that the top edge of the second label is at the same height as the top edge of the media sensor plate.
Position the label where the media sensor can detect it.
[BrotherGlobalSupport] faqp00100086_000 RJ-3150 How do I set the L
RJ-3150
137 / 237
Содержание RJ-3150
Страница 112: ...RJ 3150 Go to Index Go to Index 106 237 ...