Brother RJ-2035B, Руководство пользователя, Страница: 46 / 62

42
5.1 The Gap/Black Mark Sensors Calibration
The Gap/Black Mark Sensor sensitivity should be calibrated when:

A new printer is purchased

Label media is changed
To calibrate the Gap/Black Mark Sensor:
1. Turn off the printer.
2. Press and hold the
Feed/Pause button ( ) and then turn on the printer.
3. Release the Feed/Pause button when the printer's Status LED changes to
and starts blinking.

The LEDs will change as follows:
(Orange)

(5 times)

(5 times)

(5 times)

(Green (lit))
After calibration is complete, you can resume printing.
Release the Feed/Pause button
to enter calibration mode.