ControlCenter2
174
10
File
10
The
Scan to File
feature lets you scan an image to a folder on your hard disk in any file format. This lets you
easily archive your paper documents. To configure the file type and folder, click the button while holding down
the
Ctrl
key and choose
Software Button
.
You can change the File Name. Enter the file name you want to use for the document (up to 100 characters)
in the
File Name
box. File name will be the file name you registered, current date and sequential number.
Choose the file type for the saved image from the
File Type
pop-up menu. You can save the file to the default
folder, or choose your preferred folder by clicking the
Browse
button.
To show where the scanned image is saved when scanning is finished, check
Show Folder
box. To specify
the destination of the scanned image everytime, check
Show Save As Window
box.
If you want to scan and then crop a portion of a page after pre-scanning the document, check the
Show
Scanner Interface
box.
If you want to scan a duplex document, check
Duplex (two-sided) Scanning
and choose
Long-edge binding
or
Short-edge binding
. (For MFC-9560CDW)
Note
Содержание MFC-9*970CDW
Страница 8: ...Section I Machine operation keys I Using the control panel 2 ...
Страница 126: ...Section III Apple Macintosh III Printing and Faxing 120 Scanning 151 ControlCenter2 166 Remote Setup 187 ...
Страница 196: ...Section IV Using The Scan key IV Scanning For USB cable users 190 Network Scanning 200 ...