Brother Innov-is NX600, Руководство по обслуживанию

Страница: 148 / 214

3 - 72
Modules Feed module
21
F gear teeth alignment
1. Apply a small amount of Epnoc Grease AP to the feed adjuster assy. F gear
1
.
2. Turn the F pulse motor gear clockwise until the stopper
2
on it touches the
bushing supporter assy. shaft
3
.
3. Turn the feed adjuster assy.
4
until it touches
5
the F pulse motor gear.
*Key point
• Once the feed adjuster assy. 4 and F pulse motor gear are
touching, hold the F pulse motor gear with your finger
6
so
that it does not turn.
4. Push the feed adjuster assy.
4
until it and the F gear
7
have their gears
aligned
8
.
5. With the gears
8
aligned, push them down, and mesh the feed adjuster
assy.
4
and F pulse motor gears.
*Key point
• Check that the feed adjuster assy.
4
gear match mark
9
and
the F pulse motor gear match mark ; are together.
Start movie clip (CD-ROM version only)
Apply Epnoc Grease AP to the all of the teeth on the
feed adjuster assy. F gear
Small amount
2 1
6 5
9 , ;
3
6 8
4 7
Gear is offset
Gear aligned