Brother Innov-is NX600, Руководство по обслуживанию

Страница: 146 / 214

3 - 70
Feed module Modules
17
Outer rotary hook assy. attachment
1. Apply a small amount of Molykote EM30L to the shaft supporter
1
.
2. Install the outer rotary hook shaft
2
, spacer (thin)
3
, outer rotary hook
assy.
4
, washer 6 (thick)
5
and the spacer (thin)
3
.
*Key point
• With the D cut 6 in the lower shaft B facing upward, attach so
that the solid dot
7
on the rotary hook assy. faces forward.
*Attach from a position where 7 is 45 deg. to the right.
3. Install the screw
1
in the shaft supporter.
Start movie clip (CD-ROM version only)
Apply Molykote EM30L grease to the shaft supporter
surface
Small amount
Lubricate the outer rotary hook shaft with Sewing Lube Apply liberally
1
Torque
1.18 – 1.57 N·m
1
1
2
3
4
5
3
1
7
6
Set Screw, Socket (CP)
M4X6
Color; Black
18
Inner rotary hook bracket assy. attachment
1. Align the inner rotary hook bracket assy.
1
with the stopper plate block,
and hand start the screw
1
(Fully tighten after 4 - 28"Inner rotary hook bracket position adjustment.")
Start movie clip (CD-ROM version only)
1
Torque
0.78 – 1.18 N·m
1 1
Screw, Bind
M2X3
Color; Silver
19
Assembling F pulse motor assembly
1. Attach the rubber
1
to the FPM holder assy.
2
.
2. Attach the F pulse motor (FPM35SP-9N)
3
to the FPM holder assy.
2
using the screws the screws
1
(two).
3. Lubricate the F pulse motor (FPM35SP-9N)
2
bearing
4
with turbine oil
#100.
Start movie clip (CD-ROM version only)
Lubricate the FPM bearing with turbine oil #100. 1 – 2 drops
1
Torque
0.78 – 1.18 N·m
3
1
2
1
4
Screw, Bind
M 3X5
Color; Silver