Brother Innov-is NX600, Руководство по обслуживанию

Страница: 107 / 214

3 - 31
Electrical parts and motors Main unit
Assembly
16
Lead assy. processing
1. Attach the BH lead assy. to the BH switch assy.
2. Pass the Z pulse motor and LED lamp FL leads over the wire clip.
3. Fasten the BH switch assy. connector using the lower wire clip, and fasten
the other leads using the upper wire clip.
4. Fasten the various leads with a band on the upper side of the wire clip.
*Key point
• When cutting off the excess band, face the band toward the
inside so that it does not fly outward.
5. Pass the lead bundle along the top of the arm bed rib, hold together with a
band.
6. Pass the leads from the presser switch
1
as shown in the diagram to the
right, and bind to the other leads with a band.
7. Fasten the lead bundle with the wire clip on the middle of the back of the
arm bed and pass to the front of the arm bed from the lead assy. guide of
power supply unit F.
8. Run the BW-F SW assy.
2
leads to the front of the arm bed from the lead
assy. guide of power supply unit F.
9. Pass the C pulse motor leads to the inside of the feed module leadline guide
holder.
10. Tie the C pulse motor, F pulse motor and main motor leads together with a
wire clip.
*Key point
• Leads should not have slack.
11. Pass to the upper side from the lower PCB holder hook.
Start movie clip (CD-ROM version only)
Pass over the top of the clip
Pass along the top of the rib
1
Hold together with wire clip
Pass through the
leadline guide holder Hook
Lead assy. guide
2
Fasten the other leads together
Fasten with the lower wire clip
Connect the connector