TCP/IP CONFIGURATION 11 - 9
NC9100h_FM6.0
Using BOOTP to Configure the IP Address
BOOTP is an alternative to rarp that has the advantage of allowing
configuration of the subnet mask and gateway. In order to use
BOOTP to configure the IP address make sure that BOOTP is
installed and running on your host computer (it should appear in the
/etc/services
file on your host as a real service; type
man
bootpd
or refer to your system documentation for information).
BOOTP is usually started up via the
/etc/inetd.conf
file, so you
may need to enable it by removing the “#” in front of the bootp entry
in that file. For example, a typical bootp entry in the /etc/inetd.conf file
would be:
#bootp dgram udp wait /usr/etc/bootpd bootpd -i
Depending on the system, this entry might be called “bootps” instead
of “bootp”.
BRN_310107 1 00:80:77:31:01:07 192.189.207.3
and:
BRN_310107:ht=ethernet:ha=008077310107:\
ip=192.189.207.3:
In order to enable BOOTP, simply use an editor to delete the
“#” (if there is no “#”, then BOOTP is already enabled). Then
edit the BOOTP configuration file (usually /etc/bootptab) and
enter the name, network type (1 for Ethernet), Ethernet
address and the IP address, subnet mask and gateway of the
Print/Fax server. Unfortunately, the exact format for doing
this is not standardized, so you will need to refer to your
system documentation to determine how to enter this
information (many UNIX systems also have template
examples in the bootptab file that you can use for reference).
Some examples of typical /etc/bootptab entries include:
