Assembly
Name:
Components
included with unit:
MUFFINS PC852/ WOOD 03A
Table Lamp
Switch off power at main circuit panel prior to installation!
The manufacturer assumes no liability for damage resulting from incorrect installation.
3x hex screw (M5x30), 1x hex key, 1x glass shade,
1x wooden body, Ehmann Dimmer, 1 pair cotton gloves, 1x installation
manual
Assembling the light
Install the light source.
Insert the glass shade into the wooden body. Secure it by tightening the three M5x16 hex screws until
they are perfectly flush with the surface of the wood. If the screws are not sufficiently tightened, i.e., they
protrude from the surface of the wood, the glass shade may fall out of the wooden body; on the contrary,
excessive tightening of the screws, i.e., sinking them beneath the surface of the wood, will likely result in
damage to the glass shade. The manufacturer assumes no liability for such damage.
1.
Package contents
Removing the glass shade and disassembling the light (1 person)
To remove the glass shade, follow the steps for installation in reverse order. The light can now be disas-
sembled (e.g., on a table).
Prior to shipping, the functionality of each lamp and its components is thoroughly tested.
The manufacturer assumes no liability for the mishandling of products.
Installation time: 20 min (1 person)
TECHNICAL SUPPORT
www.brokis.cz
OFFICE
Španielova 1315/25, Praha Řepy, 16300, Czech Republic
ID 64940799, VAT CZ64940799
SHOWROOM AND FACTORY
Sídliště Janštejn 39, Horní Dubenky, 588 52,
Czech Republic
526
530
In order to eliminate potential danger in the case of damage to the outer flexible power cable of the
light, it must be replaced only by the manufacturer, one of the manufacturer’s service technicians,
or a similarly qualified person.
