P a g e
| 25
web: brohn.com.au
IMPORTANT: WHEREVER THIS APPLIANCE IS INSTALLED, AT HOME, IN MARINE
CRAFT OR CARAVAN, IT SHALL NOT BE USED AS A SPACE HEATER.
GAS TAP MAINTENANCE
These maintenance operations MUST ONLY be carried out by a licensed gas
fitter.
IMPORTANT: Before carrying out any maintenance operations, disconnect the
appliance from the gas and electricity supplies.
If a gas tap becomes stiff to operate, then you should proceed as follows:
Remove the control knobs, pan supports, burners, hob fixing screws and clamps.
Remove the hob from the worktop and remove any underside protective covers.
Disconnect the fixings holding the tap to the fascia panel and separate the
assembly. Clean the cone and seating, with a cloth dampened with solvent.
Lightly smear the cone with high temperature grease, reassemble into position and
rotate several times.
Remove the cone again and remove any excess grease, ensuring that the gas
ducts are not obstructed with grease.
Carefully reassemble the components and perform a gas soundness test.
If it becomes necessary to replace a gas tap, then you should proceed as follows:
Remove the control knobs, pan supports, burners, hob fixing screws and clamps.
Remove the hob from the worktop and remove any underside protective covers.
Disconnect the fixings holding the tap to the fascia panel and separate the
assembly.
Disconnect the gas pipe from the gas tap, and then disassemble them from the gas
rail by removing the fixing screws.
When fitting a new tap ensure that a new gasket is used.
Reconnect the gas tap, perform a gas soundness test and then reassemble the hob.
ELECTRICAL CONNECTION
Power hardwiring connection of the cooktop must be installed by a licensed
electrician.
Before connecting the appliance, make sure that the supply voltage marked on the
rating plate corresponds with your mains supply voltage.