6 May, 2020, www.brodit.com, © 2020 Brodit AB
Product 713160
713160 Active holder for fixed installation With tilt swivel. 3A charging. 12/24V. With Easy-switching system.
An active holder which is to be connected inside the dashboard, this gives a discreet, neat installation without
cables hanging over the interior!
You can choose to use the holder as an active holder for charging of your device only, or to connect an adapter
to the Molex connector for additional features. Then you can use the holder also for power supply of a GPS
receiver or other own solutions (can not be used for data communication or audio connection). 12/24 Volt. The
product is E-approved. Connect the power cable with a 3 A fuse. 3 A charger. Professional installation
recommended.
Easy-switching system:
The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a
lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for
maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the
Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds.
The holder is equipped with a tilt swivel so you can easily adjust the angle for better viewing, or switch between
portrait and landscape mode. Tilts 17° and swivels 360°. Mounting plate 42x50 mm with 4 mm AMPS-holes.
Made of high grade black ABS/Acetal plastic. Made in Sweden. Connect the power cable with a 3A fuse.
Professional installation recommended. Attach onto a ProClip Mounting Platform or a Pedestal Mount.
EAN: 7320287131604
Item no 713160 fits:
Worktab WT8005 (For all countries)
