Brocade Communications Systems X6-4, Руководство по установке оборудования, Страница: 40 / 249

5. Secure the device to the rack with six 10-32 screws with washers, three screws on each side (refer to the following figure).
Tighten the screws according to specifications under Torque requirements on page 33.
NOTE
Screws, clip nuts, and retainer nuts for securing the device to the equipment rack are included in the device hardware
accessory kit.
FIGURE 9 Brocade device with 18-24 in. (45.72 to 60.96 cm) kit installed in rack
1. 10-32 x .63 in.(1.60 cm) Phillips screw with square cone
washer for racks that have rails with round holes
NOTE
For rails with round holes, use the clip nuts on the front rails for securing 10-32 screws. For rails with square holes,
use the retainer nuts (refer to
Figure 3 on page 33). Also refer to Figure 4 on page 34.
6. Reinstall the device door if removed. Refer to procedures for removing and replacing the device door in this guide.
Installing the device in a 27-31-inch rack (XBR-DCX4S-0121)
Use the following instructions to install the device in a rack with rail-to-rail depth of 27 to 31 in. (68.58 to 78.74 cm). Be sure to use the
27-31 in. 8U Chassis Airflow Diversion and Port Side Exhaust Kit for Four-Post Rack (XBR-DCX4S-0121) for this installation.
Installing the 8U Chassis Airflow Diversion or Port Side Exhaust Kit for Four-Post Racks (XBR-DCX4S-0121 and XBR-DCX4S-0130)
Brocade X6-4 Director Hardware Installation Guide
40 53-1004106-07