Brocade Communications Systems X6-4, Руководство по установке оборудования, Страница: 24 / 249

TABLE 3 Facility requirements (continued)
Type Requirements
Ensure that the rack meets these additional requirements:
• Additional weight of chassis will not exceed the rack’s weight limits.
• The rack is secured to ensure stability in case of unexpected movement.
Time and items required for installation
You can set up and install the device in the following ways:
• As a standalone unit on a flat surface.
• In a 19-inch Electronic Industries Association (EIA) rack or in a telecommunications (Telco) rack using a Brocade rack mount kit.
Refer to
Mounting options on page 29 for applicable rack mount kits.
The following table describes the main installation and setup tasks, the estimated time required for each, and the items required to
complete the task for a device that is fully populated with port blades. Configurations with fewer blades or ports require less time. These
time estimates assume a prepared installation site and appropriate power and network connectivity.
TABLE 4 Installation tasks, time, and items required
Installation task Time estimate Items required
Site preparation and unpacking the device. 30 minutes 1/2-in. socket wrench (optional).
#1 and #2 Phillips screwdrivers.
Pallet jack.
Hydraulic lift or assisted lift, able to raise to a minimum of
140 cm (55 in.), with a minimum capacity of 115 kg (254
lb).
To find the weight of your device fully populated with the
required port blades, refer to
Brocade X6 Directors
Technical Specifications on page 225.
Installing rack mount kit . 30 minutes Refer the procedures for your rack mount kit located in this
guide.
Mounting and securing the device in rack. 30 minutes
Installing power cables and powering on the device. 20 minutes Power cables. These are ordered and shipped separately
based on country where device is installed.
Establishing serial connection, logging in to the device, and
configuring IP addresses. 20 minutes Serial cable (provided in the accessory kit).
Workstation computer with a serial port or terminal server
port and a terminal emulator application (such as
HyperTerminal).
Ethernet IP addresses for the device and for both control
processor blades; total of three addresses.
Installing an Ethernet cable, opening a Telnet session, and
configuring the device domain ID, date and time, and
additional system parameters. Verify and back up
configuration. 20 minutes Ethernet cabling (optional) for Telnet access.
Refer to the Brocade Fabric OS Administration Guide .
Installing transceivers as needed. 20-30 minutes or longer if
you are using high-density
port blades. SFP+ and QSFP28 optical transceivers as needed.
Attaching fiber-optic cables, cable ties, and cable guides. 2-3 hours Fiber-optic cables and cable ties.
Time and items required for installation
Brocade X6-4 Director Hardware Installation Guide
24 53-1004106-07